KIMO EV TEST100 EVSE Adapter Charger Testing

KIMO EV TEST100 EVSE Adapter for Electric Vehicle Charger Testing

The KIMO EV TEST100 EVSE Adapter Charger Testing, together with the special HT multifunction device, simulates an electric vehicle connected to the charging station, thus enabling all functions and electrical safety of the EVSE to be checked. EV-TEST100 is able to test charging stations with charging modes 2 and 3 and type 2 plugs (European standard).

Using the button, it is possible to simulate an interruption of the protective conductor (PE error) and an error on the CP signal (error E) one after the other. For an incredible purchase of the KIMO EV TEST100 EVSE Adapter Charger Testing device at the best possible price and quality, visit the MME website.

KIMO EV TEST100 EVSE Adapter Features

• 4 mm universal sockets for connection to a single-phase or three-phase installation tester with test leads (banana plugs)
• Separate phase indicator with three LEDs for easy voltage monitoring
• Rotating proximity switch (PP) to simulate different nominal currents of the charging cable
• Control Pilot (CP) rotary switch to simulate the condition of the electric vehicle A, B, C D
• Rotary switch error simulating a short circuit between CP and PE (state E = error)
• Simulation of a PE error (earth fault). )
• Connection for CP signal output for testing the communication between the adapter (= simulated electric vehicle) and charging station
• Type 2 plug for connection to the charging station itself with the charging cable connected permanently
• Vehicle simulation (CP): Different vehicle states A to D can be monitored via the Rotary knob can be simulated (according to IEC 61851)
• Cable simulation (PP): Various codings for load cables 13, 20, 32, and 63 A and “no cable connected” can be simulated using the rotary switch.
• Error simulation: Simulation of a short circuit between CP and PE using a rotary switch (state E = error)
• Visualization of the phase voltages via LED
• Testing of the charging station even with a permanently connected charging cable

KIMO EV TEST100 Specifications:

• Functions:  Use for EVSE charging stations Charging modes 2 and 3
• Test cable with connector Type 2 (IEC 62196-2), Cosphi, Power Factor
• Vehicle simulation via Control Pilot (CP state) States A, B, C, D
• Simulating the current capacity of Proximity Pilot (PP state) NC, 13A, 30A, 32A, 63A
• Fault condition simulation on PE FAULT PE
• Diode simulation in short circuit FAULT PE
• EVSE internal counter efficiency check LOAD
• Input voltage Max 415V AC, Phase-Phase, 50 / 60Hz
• External load L-N-PE 240V 50/60Hz, Max 10A AC, CP signal PWM 12V
• External load protection Fuse FF 10A / 250V, 5x20mm, Operating temperature 0°C ÷ 40°C
• Operating humidity <80&RH
• Guidelines: IEC/EN60364-7-722, IEC/EN61010-1, IEC/EN61851-1